Intermatic CA9000 PIR Occupancy Sensor

The CA9000 PIR Occupancy Sensor is a Z-Wave enabled device which is fully compatible with any Z-Wave enabled network. Z-Wave enabled devices display the Z-Wave logo and guarantee connectivity and interoperability between devices. Each line powered node in a Z-Wave network is designed to act as a repeater forming a mesh network eliminating radio "dead spots" and providing the highest level of reliability.

Features

  • Multiple location On/Off control when used with Z-Wave enabled devices.
  • Pre-set scene control when used with up to 5 Z-Wave enabled devices.
  • Full 229 device scene control when used with Intermatic InTouch server (CA5500B).
  • Twin pyro sensor elements provide for high accuracy and reliability.
  • Wide detection pattern can be used for whole room coverage.
  • 3-Mounting options; Adjustable swivel neck rotates 30 degrees vertically and horizontally, Flat on wall, or Corner mount.
  • Adjustable timing interval features settings for pulse, 5 minute, 10 minute, 15 minute, and Manual Off time ranges.
  • Meets ASHRAE Standard 90.1 requirements.

Passive Infrared (PIR)

Passive Infrared occupancy sensors are designed to sense the motion of objects or bodies that are radiating heat. These sensors are installed to monitor areas where there are limited physical obstructions that could block the sensor's field of vision.
HOW THEY WORK: The human body naturally radiates heat in the form of infrared energy. As a body crosses through the sensor's field of visioin, it "sees" the motion as a change in the pattern of infrared energy it is receiving.

Installation:

  • Mount sensor in location with clear view of area to be monitored using included tilt-swivel base or adhesive strips.
  • Separate rear housing from front by lifting upwards, install three (3) AA alkaline batteries in front housing and reattach to rear housing.
  • Operation: Press the activator button to enable and disable the sensor. Set the mode selector switch to desired mode: Pulse, 5 Min delay, 10 Min delay, 15 Min Delay or Manual Off mode.
  • For programming instructions refer to the InTouch Installer & Users Guide (158CA12789)

Note: Indicator LED will flash BLUE and RED until device is included into a Z-Wave network.

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License